Notifications
Clear all
E-HERMS In General
3
Posts
2
Users
0
Likes
1,063
Views
Topic starter
03/03/2020 3:27 pm
Hi there! Looking at parts and wondering what the pros/cons are of using a pick up tube for the Water In from the coupler; something like this:
...instead of the elbow, compression, and tube?
04/03/2020 2:27 pm
Hi Nick,
I’m not sure if it matters. I think a good swirl helps to get an even temperature in the HLT. Will you get the same swirl with this pick up tube? I think you'll be fine. You could also bend it to get a better angel but stainless is stiff and you will most likely need to heat the metal to bend the tube.
Good luck!
Topic starter
04/03/2020 4:17 pm
Thanks Michael, after looking at some other builds and their reasoning I figured that was the case. Was thinking that it should be possible to further reduce the cost but the difference was minimal or not even there!